Tractor oil spill is a lot of farmer friend trouble, how in the premise of promoting the production, to ensure that the use of solving the tractor parts in the machine oil leakage problem? Some simple methods to establish a letter of professional pipe joint introduction may help you in your.

Rotary shaft oil leakage of rotary shaft comprises a starter gear shaft clutch lever shaft and engine decompression shaft.

If because of shaft and hole wear between, the starter gear shaft and the clutchhandle shaft in lathe cut gasket groove, this time as long as installed on thecorresponding size of the sealing ring can be bite. If the decompression shaft rubber ring aging, it should be replaced with new rubber ring.

If ball wear or corrosion, rust should be removed between the ball and seat hole,and choosing the right ball substitute. If because of the sealing filler and thefastening screw is damaged, to be repaired or replaced the fasteners and replace the seal packing. If the taper joint face is not tight, usable fine sand and oil grinding valve.

Oil pipe joint comprises a pipe joint of conical joint and a hollow bolt pipe joint two categories.

Cone joint pipe joint comprises a pressure gauge at both ends, one end of the gasoline pipe, pipe joint pump end of the high-pressure tubing at both ends andcoarse fuel filter to, if because of the high pressure pipe joint wear deformation orcrack, which can be sawed off, for a good joint welding. If because of low pressureoil pipe joint damage, can be amputated trumpet, re create the bell. If because ofthe screw thread damage should be repaired or replaced with new parts. Hollow bolt pipe joint comprises a coarse and fine filter and fuel injection pump low pressure oil pipe connector etc.. If because of uneven gasket damaged orassembly, can be replaced by a plastic gasket, or use the assorted file Xiuping,also can use sand down milling the severity of flat available. If because of the pipe joint assembly planes on which stretch marks, usable fine sandpaper or using an oilstone grinding joint assembly plane and gasket; because if the mating surfaceimpurities, the assembly should pay attention to the body clean, joint fixing bolts should be tightened evenly.

If because of the oil plug screw damage or failure, should be replaced with newpieces; if because of screw screw screw damaged, can increase the size, equipped with new oil plug; if because of conical casing wear, can tap tapping is changed after flat plug, then padded refitted use.

If because of the contact surface is uneven or ditch mark or burr contact surface,should be based on the contact surface rough degree, with assorted file, fine sandpaper or oilstone grinding, large usable machine milling. In addition, the assembly of the gasket to qualify, at the same time to clean. If because of loose bolts should be tightened each fixing bolt.