Tractor oil spill is a lot of farmer friend trouble, how in the premise of promotingproduction, ensure the tractors, Lixin professional pipe joint tells you how to solve the various parts in the machine oil leakage problems?
1 shaft oil leakage. Rotary shaft comprises a starter gear shaft clutch lever shaft andengine decompression shaft. Lixin professional pipe joint for mutual abrasion and said that if the shaft hole, the starter gear shaft and the clutch handle shaft in lathe cutgasket groove, this time as long as installed on the corresponding size of the sealingring can be bite. If the decompression shaft ring aging, it should be replaced with newrubber ring.
The 2 switch leakage. Including water valve, the fuel tank switch and gas switch. If ball wear or corrosion, rust should be removed between the ball and seat hole, and choosing the right ball substitute. If because of the sealing filler and the fasteningscrew is damaged, to be repaired or replaced the fasteners and replace the seal packing. If the taper joint face is not tight, usable fine sand and oil grinding valve.
The 3 joint leakage. Pipe joint comprises a conical hollow bolt joint and the pipe jointtwo categories. Cone joint pipe joint comprises a pressure gauge at both ends, one end of the gasoline pipe, pipe joint pump end of the high-pressure tubing at both endsand coarse fuel filter to, if because of the high pressure pipe joint wear deformation orcrack, which can be sawed off, for a good joint welding. If because of low pressure oil pipe joint damage, can be amputated trumpet, re create the bell. If because of the screw thread damage should be repaired or replaced with new parts. Hollow bolt pipejoint comprises a coarse and fine filter and fuel injection pump low pressure oil pipe connector etc.. If because of uneven gasket damaged or assembly, can be replaced by a plastic gasket, or use the assorted file Xiuping, also can use sand down millingthe severity of flat available. If because of the pipe joint assembly planes on whichstretch marks, usable fine sandpaper or using an oilstone grinding joint assemblyplane and gasket; because if the mating surface impurities, the assembly should pay attention to the body clean, joint fixing bolts should be tightened evenly.
The 4 joint leakage. Plane joint comprises a paper pad, asbestos pad and cork sealedthe two plane etc.. Lixin professional pipe joint said that if because of the contact surface is uneven or ditch mark or burr contact surface, should be based on thecontact surface rough degree, with assorted file, fine sandpaper or stone removed,large usable machine milling. In addition, the assembly of the gasket to be qualified, at the same time to clean. If because of the loosening of the bolts should be tightened,each fixing bolt. |
