Tractor Oil spills are a lot of tractor headache, in the event of oil spills, will not only affect the normal work, but also wasteful.
     1. Shaft oil spill. Back to the shaft including starter shift lever shaft and the clutch shaft engine decompression shaft. Due to the shaft and bore each other wear, the car starter shift lever shaft and clutch shaft in the lathe seal ring groove, then as long as the installed sealing gasket can be of the appropriate size. Due to the the decompression shaft apron aging failure should be replaced with new apron.

2. Switch oil spill. Including the valve, fuel tank switch and gasoline switch. Due to the ball valve is worn or corroded oil spill, a rust hole between the ball valve and the seat should be cleared, and select the appropriate substitute the steel ball. Due to damage to the seal packing and fastening thread, you should repair or replace the fasteners and replace the gland packing. Due to the the cone joint surface imprecise, available fine valve sand and oil grinding.

3 pipe joint oil spill. The tube fitting comprises a tapered surface engaging and two categories of pipe joint of the hollow bolt. Cone bonded pipe joints, including both ends of the pressure gauge, gasoline pipe at one end, both ends of the high pressure tubing and fuel filter to the output oil pump at one end of the pipe joints. Due to the high-pressure pipeline joints wear deformation or cracks, it can be cut out, for a good joint welding. Due to low pressure tubing connector is damaged, can be sawed off the bell, to re-create the bell. Due to thread damage should be repaired or replaced with new parts. The hollow bolt pipe joints including fuel coarse, fine filter and fuel pump low pressure pipeline joints. Because the gasket is damaged or the assembly uneven convertible is also available with a plastic gasket, or needle files Shuhei sandpaper available milling milling. Due to the tube connector assembly plane pull marks available fine sandpaper or oil stone flat plane of the connector assembly and gaskets; due to the mating surface impurities, the assembly should pay attention to the body clean joints fixing bolts should be tightened evenly.

4 oil plugging oil. Plugging the oil drain plug oil section includes The cone blocking, blocking and process stall. Ruoyin oil plug screw damage or unqualified, should be replaced with new parts: due to the screw holes screws damaged, can increase the screw size, equipped with a new oil plug: to level due to the tapered block wear, available tap tapping block, then refitted to use padded.

5 seams oil spill. Flat seams including paper mat, asbestos mat and cork sealed two planes. Due to the contact surface is uneven or contact surface grooves or burrs should be based on the contact surface roughness of needle files, fine sandpaper or Whetstone polished, large available machine milling. In addition, the assembly of the gasket to be qualified, while cleaning. Due to loose bolts, tighten each mounting bolts.

6, the hollow bolt pipe joint oil spill: due connector assembly plane pull very polished with fine sandpaper or Whetstone joints due to the mating surface impurities, pay attention to the body assembly cleaning joints fixing bolts are tighten.

7, oil plugging oil: Ruoyin oil blocking bolt damaged should be replaced with new parts, due to damage to the screw holes bolt, screw size can increase the assembly of new oil plug.

8, shaft oil spill: decompression apron aging lapse, should be replaced with new apron, due to the shaft and bore each other wear, the starter gear lever shaft and the clutch shaft lathe cut seal ring groove, as long as sealing gasket can be installed on the appropriate size.